How to Clean Indoor Water Fountain

How to Clean Indoor Water Fountain

Indoor fountains are best if you want to give your mind a calm and soothing feeling. The water flowing from the fountain emits negative ions which destroy the electric radiation inside the room. These negative ions also increase the amount of oxygen in your brain. There are many types of indoor fountains including tabletop, floor, stand and waterfall fountains. Here we will discuss how to clean a medium-sized indoor fountain. Cleaning rules for table tops fountains or small fountains are the same but different.

Why Cleaning an Indoor fountain Is Necessary

  1. Waste of water causes a bad smell inside the house.
  2. The beauty of the fountain is lost.
  3. The motor makes a lot of noise and can stop at any time.
  4. To enhance the beauty of the interior of the house.
  5. Good quality negative ions and bad radiation destroy quickly.

How Often to Clean an Indoor Water Fountain

Like outdoor fountains, indoor fountains require regular cleaning. The main cause of dirty indoor fountains is water wastage. If you use ordinary water, the water gets wasted very quickly. Also, common water minerals can discolour the fountain. Most of the damage is done to the motor, which causes the motor to fail. If you use normal water, you must clean it after three months. And if you use distilled water and change it regularly, you can clean it after six months.

Needed Supplies

Equipment / Tools: Scrub brush, Rubber gloves, Pressure attachment hose (optional).

Materials: Water, Chlorine bleach.

Instructions

1. Dump Out the Old Water

The main rule of thumb for fountain cleaning is to drain all water from the fountain basin. Before pouring water, check all parts of the fountain to make sure nothing is damaged. The basin is attached to the fountain in indoor fountains, so the parts cannot separate. Throw away the dirt in the fountain basin along with the water.

2. Remove Pump

Remove the motor from the lower basin after draining all the water from the fountain. Also, take out the motor pipe. Removing the motor makes the motor easier to clean and the fountain easier to clean.

3. Clean the Pump

It is important to clean the motor while cleaning the fountain. If the motor is not cleaned for a long time, the motor may make a water noise. If you use normal water, the motor gets dirty, which gets dirty on the fountain. The fan inside the fountain should clean while cleaning the fountain. Minerals in normal water sit on the motor fan and reduce the water flow capacity of the motor fan. It is best to use a pressure attachment hose and a scrub brush to clean the motor, which cleans the internal fan well.

4. Clean all Spouts and Tubing

The mistake everyone makes when cleaning a fountain is cleaning everything but not cleaning fountain tubes. If the tube is not cleaned, the fountain will become dirty again within a few days. So it is important to clean the fountain tube. To clean the tube, immerse the tube in water mixed with chlorine bleach for 10 minutes. Then run water very fast between the tubes. After cleaning, dry the tube with the motor in the sun.

5. Clean the Indoor Fountain Basin

After cleaning the inside of the fountain, the outside of the fountain should be cleaned. To clean the fountain basin:

  1. Rinse the basin with clean water.
  2. Sprinkle chlorine bleach inside the basin and leave it for 10 minutes.
  3. When the dirt in the basin is soft, scrub it well with a scrub brush.

If not cleaned for a long time, the water in the house gets stained, which spoils the house’s beauty. Leave it on for a while with bleach to get rid of stubborn stains. Care should be taken that no pets or children touch it.

6. Rinse the Indoor Fountain

When it seems that all the dirt in the fountain has been removed, rinse it thoroughly with water. Wash the outside of the fountain as well as the basin of the fountain well because a clean indoor fountain enhances the house’s beauty. If bleach is used, it should wash several times with clean water because bleach can damage the fountain if it gets mixed with water!

7. Allow the Indoor fountain to Dry Outside

After cleaning, the fountain should be thoroughly dried in the sun to keep it free of dirt and algae for a long time. If not, algae build up and spoil the fountain water. After cleaning all the fountain parts, dry them in the sun for 2 hours.

8. Assemble Indoor Fountains Perfectly

After cleaning and drying the fountain, the fountain must assemble. Observe the fountain while assembling. Otherwise, the sound of the fountain’s water flow will not be good. Also, the water from the fountain can get out of the fountain and spoil the environment.

9. Refill the Indoor Fountain Basin

After drying all the parts of the fountain thoroughly, assemble all the parts of the fountain. Check that the motor is properly seated because if the motor is not seated properly, the motor will make bad noise. Once everything is set, fill the fountain with enough water. Then turn it on and enjoy the soothing sound of the fountain.

Tips for Keeping Your Indoor Fountain Cleaner Longer

Even after cleaning the indoor fountain for a long time, if you follow some rules, the fountain will not get dirty or stained easily. If there is dirt in the fountain inside the house, it spoils the beauty of the fountain and spoils the beauty of the decoration of the house. So by following some simple rules, the fountain can be easily kept clean.

  1. It is better to use distilled water in all types of fountains inside the house so that the water does not get wasted easily.
  2. When changing water, discard old water and then use new water.
  3. Scrub the basin with a scrub brush while changing the water.
  4. Keep away from pets as water spoils quickly after they drink.
  5. Use EasyCare FounTec Algaecide to keep algae-free.

Related Articles